Provide your contact details to the exhibitor. Optionally, you may also add a personal message.
Your name, phone number, and e-mail address are subject to the submission of personal data. Messe Düsseldorf GmbH expressly points out that for a data transmission into third countries, for which no adequacy decision of the EU-commission is on hand certifying an adequate level of protection of personal data, it is not ensured that there are appropriate safeguards for the protection of personal data on hand.
Please log in
You must be logged in to send the contact request.
An error has occurred
Please check your internet connection or try again later.
Message has been sent
Your message to the exhibitor was sent successfully.
Product category: Neurosurgical instruments and equipment
TALOS The Talos system is an innovative system for closure and full reconstruction of trepanning defects.
Absorption of bone flaps after cranioplasty which followed craniotomy or craniectomy has been reported in the literature, especially in cases of large flaps, bilateral flaps, or in cases with significant time interval between removal and replacement of the bone. It appears that the use of bone graft, especially of a human one, within the margins of the incision, inhibits absorption phenomena to a great extend.
The Talos system outranks the use of bone graft fragments because it offers firm insertion of a single graft, at the point of the greatest bone deficit, which does not diffuse to the surrounding tissue and does not cause ectopic osteogenesis, while offering great cosmetic results.
Product category: Neurosurgical instruments and equipment, Other implants and protheses
The TALOS-BIO project is a collaboration between the Human Tissue Bank of National Center for Scientific Research “DEMOKRITOS”, and the private company “Filippos Healthcare”, which has launched the TALOS system. In this project DEMOKRITOS and Filippos Healthcare are going to design and manufacture a special set of instruments in order to produce a new innovative bone allograft from living donors, especially shaped to be used with the TALOS milling head in Neurosurgery, as TALOS-BIO system.
The TALOS-BIO system consists of a special configuration milling head accompanied with one or more bone graft discs, which can be of human origin or synthetic. It is used in all treppaning methods, individual (endoscopy, stereotaxy, minimal invasive surgery) and in any type of craniotomy.
The newly developed disc-shaped bone allograft is the novelty which will replace the contemporary synthetic grafts.
The TALOS-BIO System allows a firm insertion of a one-piece graft, instead of many bone fragments, at the point of the largest bone deficit, a feature that offers also the best cosmetic result.
Product category: Neurosurgical instruments and equipment, Other diagnostic equipment
Palos Guide is a unique product manufactured in E.U. and meets the requirements and regulations in place, as stated by the manufacturer Arkodia Business Ltd. who are ISO 9001 and ISO 13485 certified for the Proper Practices of Manufacturing and Distribution of this product.
Application Palos Guide is placed on the skin of the patient at the area of interest.
Trident material Stainless Steel 316L.
Adhesive Patch properties Non-allergic, non-woven, adhesive material allowing easy and safe anatomical application.
Function Defines entry point level for a multitude of surgery types.
Easy and safe mode of defining the entry point and access angle for every type of surgery. After the placement of Palos Guide on the patient skin before the radiologic control, three points of reference can be determined, to define a Level used for pinpointing the entrance point, be it from the same Level, or from an adjacent one, as well as the access angle and the distance from the entry point up to the damage area. This system provides these extra parameters to the existing readings of radiologic diagnostic systems and tomography systems.
The device has a wide application scope in: · RADIOLOGY DIAGNOSIS & TREATMENT · NEUROSURGERY · THORACIC SURGERY · ORTHOPEDIC SURGERY · SPINE SURGERY · GENERAL SURGERY · INVASIVE SURGERY · ENT · ANESTHESIOLOGY It is distributed in non-sterile packaging.
Filippos Healthcare collaborates with the Human Tissue Bank of the National Center for Scientific Research “DEMOKRITOS”, Athens, Greece. Demokritos will produce a product especially shaped to be used with the TALOS milling head in Neurosurgery, as TALOS-BIO system.
Filippos Healthcare offers you Simple Solutions as your Indispensable Tools Sparing resources in the modern concepts of the Health Industry is paramount. Filippos Healthcare specializes in cost effective products which are safe and innovative, as well as beneficial to the patient and friendly to the Healthcare Proffessional.
Development and Manufacturing in Greece We use resources and experienced associates to create new collaborations with research centers and healthcare professionals to expand further for the Development and the Manufacturing of Systems and Solutions in Greece. In this way we wish to contribute to our national economy and to the Quality of Medical Devices we offer.
We seek Innovative Ideas We are open to new ideas and products which express our philosophy, based on Compliance and Safety. The specialization of our collaborators allows a transparent technical evaluation and a reliable feasibility assessment of every new business proposition to be transformed to a complete project.
New collaborations with Healthcare Professionals We opt to develop collaborations with Healthcare Professionals, who are able to participate in projects which offer advancements to the treatment of patients. Our relations with Healthcare Professionals are defined by national and EU regulations.
New collaborations with Research Centers We have already set up collaborations with approved organizations and research centers and we are open for new ones, both in Greece and in EU, for the realization, promotion and marketing of new technologies in the Health Industry.